Gjurmët

Icom M710 Programming Software Download ((LINK))

Icom M710 Programming Software Download

if the transmit power is low, then this likely indicates that the fsk and psk amplitude settings in airmail are not correct for your radio. (these settings control the modems audio volume control for the signal sent to the radio, and this in turn controls the transmit-power. the fsk setting is used for calling, psk once connected. psk should always be about 30% higher than fsk).
open airmails tools/options menu, connection tab, and check these settings in the lower-right. (you can also access these settings when terminal-window is open, via control/set ptc amplitude menu). older icom m710s are usually 140/170 for fsk/psk, newer m710s and m802s are usually 250/330, systems which marc robinson set up usually have special cables and are set to 600/1000, furuno radios are usually 1500/2000.

you can buy the pactor-modem yourself, figure out and make the interface cables, download the software, read the documentation, and sort it all out. if you want to take this approach, there are instructions on this website. alternatively you can get help from your marine electronicsdealer who will sell you the pactor-modem, supply theprofessionally wiredcables to connect it to your radio, hook it up, load the airmail software in your laptop, and show you how to operate it. the radio-specific cables with ferrites etc. the icm transmitter supports 2 modes: transmit and listen. once a long code is entered into the qrm, the transmitter will stop transmitting and the icom radio will switch to the listen mode. it will listen for the received signal on the selected freq. note that the transmitter will remain on the selected freq for a while after switching to the listen mode. the time depends on the mode selected. the icm, as well as most icom radios, has a dual purpose function, which is the ability to receive and transmit. this can be tested by selecting the transmit and listen mode on the tune control. note that the icom radio will remain on the selected freq for a while after switching to the listen mode. the time depends on the mode selected. if you have an id-31 with the following problem, you have a new icom m810, it's basically a newer m710 with a liquid crystal display on top of it. the m810 is in the same family as the m710, so it has the same code, and most commands work exactly the same. (the exception is that the m810 has a rotary controller, whereas the m710 has a digital button-wheel controller. the difference is that the m810 has a small lcd display on top of the unit that allows you to see the entire command-history as you press the appropriate buttons. it also allows you to navigate through the menus with the controller. whereas the m710 controller is basically a digital button-wheel, similar to the one you see on a digital clock radio). if you load the memory with your id-31, you can get it to access sailmail by pressing the "c" button twice, then pressing "m" and pressing 1. once you get it to the main menu, you can press "m" and press 2. the memory will load sailmail and you will be able to contact sailmail radio stations. 5ec8ef588b

Icom M710 Programming Software Download ((LINK))

Icom M710 Programming Software Download ((LINK))

LATEST ARTICLES:

SPONSORED BY: